how many hours Supervivi flash info takes on your mini2440?

[ekilab]

Hi I have now waited for 3 hours for the mini2440 utility supervivi
flash info command.

I have miserably failed to find any documentation to the supervivi flash info

one discussion in the web does side the subject, but my chinese is so poor, that I dont understand it.
http://blog.chinaunix.net/u2/78300/showart_1274577.html

at least there is some s3c2440 specific in the code of the blog:
case TYPE_S3C2440:

chip->IO_ADDR_W = regs + S3C2440_NFDATA;

info->sel_reg = regs + S3C2440_NFCONT;

info->sel_bit = S3C2440_NFCONT_nFCE;

chip->cmd_ctrl = s3c2440_nand_hwcontrol;

chip->dev_ready = s3c2440_nand_devready;

break;

but as subject says:
could you tell me how long it takes to get the flash info from supervivi on your board.

[the_fbi]

Is there any reason you're not using the H-JTAG application from the DVD and the Parallel JTAG adaptor?

Works fine under Windows (takes about 1 minute) and under Linux using sjf2440 (takes a few minutes).

[ekilab]

Is there any reason you're not using the H-JTAG application from the DVD and the Parallel JTAG adaptor?

Works fine under Windows (takes about 1 minute) and under Linux using sjf2440 (takes a few minutes).

lack of lpt (parallel printer) port in the PC is the reason not to use it.

[the_fbi]

Is there any reason you're not using the H-JTAG application from the DVD and the Parallel JTAG adaptor?

Works fine under Windows (takes about 1 minute) and under Linux using sjf2440 (takes a few minutes).

lack of lpt (parallel printer) port in the PC is the reason not to use it.

Thats a bit of a pain Luckily my laptop docking station has one.

Anything in this thread which helps? http://www.friendlyarm.net/forum/topic/40