www.esky-sh.com

Set Hypterminal on PC to 115200 Baudrate and no hardware flow control.
Page 32 in the manual.

bingo!!! THAT WAS IT!

You are the man!

Took out the 'A' and openocd works! THANK YOU!

Well I was not brave enough to cut the cables, so did something similar, patched the pins on a bread board and tied all the GND lines to a common tap on both the cables. (pic below). http://img196.imageshack.us/img196/3246/photomini2440.jpg The jig works with demo software from Amontec, but openocd ...

Thanks for the response, bought JTAGKey over the weekend. Would you please share the pinout and configuration for ocd. From schematics, I believe the following. JTAG on mini - Descrip 1 - VDD33V 2 - VDD33V 3 - TRST 4 - RESET 5 - TDI 6 - TDO 7 - TMS 8 - GND 9 - TCK 10 - GND On Amontec JTAG key VREF 1...

What software do I use? tried openocd, and UrJTAG. Unfortunately not sure on the configuration, google hasn't been helpful so far. Anyone? Thanks in advance.

This H-JTAG hardware came along with S3C2440 kit.